VH Vacuum Forming with motor VH- Vacuum Forming with Motor – No need compressor – Uses round and cquare plaques – 5 x 5 inches – Used for copies of models in plaster in diverse works- Aluminum Structure [ termoformadora thermoformer vacuumforming ] Dimensions 360 x 200x 350 mm – 14 x 8 x 14 in – Motor 900watts – 110 or 220 volts (0)

Filled my sloppy stock mounts with 3M Windo-Weld urethane. The result was perfect for what I wanted: stiffer than Nismo, dirt cheap ($30), and minimal cabin vibrations. The engine twists a very small amount when starting or revving. I did this in the backyard so didn’t rev too much (just 3000rpm) to disturb the neighbors. The 2nd video is here www.youtube.com

These mounts use urethane bushings instead of the stock insulators.